It’s a fact that a typical ‘bent needs wider and lower gearing than a typical upright bike. Just how much wider and lower is a subjective, sometimes technical, and oft’ debated topic that can make large chunks of time vanish. I’ll try to keep this brief. I use Gear Inches in the following discussion because it is commonly used in trike specifications and it provides a good way to make relative comparisons between drivetrains. Consult a Gear Inch Calculator to see how Gear Inches translate into speed.
While I love the idea of Internally Geared Hubs, I’ve had my share of difficulties with them over the years.
Recently I took a trip down to Payson, UT to check out internally geared hubs (IGH). This was a pretty crazy trip, 900 miles and around 12 hours of driving for a couple hours with the folks at Utah Trikes. That says a lot about my expectations for the shop and they didn’t disappoint. Continue reading